Home > Boards, SoCs, Vendors > Run FreeBSD on MOCHAbin #1

Run FreeBSD on MOCHAbin #1

May 29th, 2022

First try u-boot..

BootROM - 2.03
Starting AP IOROM 1.02
Booting from eMMC 0
Found valid image at boot postion 0x002
lmv_ddr: mv_ddr-devel-18.12.0-g2e20f5d (May 27 2022 - 18:06:24)
mv_ddr: completed successfully
BL2: Initiating SCP_BL2 transfer to SCP

U-Boot 2018.03-devel-18.12.3-g926d08c7ce (May 27 2022 - 17:55:54 +0000)

Model: Marvell Armada 7040 Mochabin development board
SoC: Armada7040-B0; AP806-B0; CP115-A0
Clock:  CPU     1400 [MHz]
        DDR     800  [MHz]
        FABRIC  800  [MHz]
        MSS     200  [MHz]
LLC Enabled (Exclusive Mode)
DRAM:  8 GiB
Bus spi@700680 CS0 configured for direct access 00000000f9000000:0x1000000
SF: Detected w25q32bv with page size 256 Bytes, erase size 4 KiB, total 4 MiB
EEPROM configuration pattern not detected.
Comphy chip #0:
Comphy-0: SGMII1        3.125 Gbps
Comphy-1: USB3_HOST0
Comphy-2: SATA0
Comphy-3: SATA1
Comphy-4: SFI0          10.3125 Gbps
Comphy-5: PEX2
UTMI PHY 0 initialized to USB Host0
UTMI PHY 1 initialized to USB Host1
SATA link 0 timeout.
Target spinup took 0 ms.
AHCI 0001.0000 32 slots 2 ports 6 Gbps 0x3 impl SATA mode
flags: 64bit ncq led only pmp fbss pio slum part sxs
PCIE-0: Link up (Gen1-x1, Bus0)
MMC:   sdhci@6e0000: 0
Loading Environment from SPI Flash... OK
Model: Marvell Armada 7040 Mochabin development board
Net:   eth0: mvpp2-0 [PRIME], eth1: mvpp2-1, eth2: mvpp2-2
Hit any key to stop autoboot:  0
Marvell>>
Marvell>> scsi scan
scanning bus for devices...
  Device 0: (1:0) Vendor: ATA Prod.: NT-256 Rev: SN95
            Type: Hard Disk
            Capacity: 244198.3 MB = 238.4 GB (500118192 x 512)

Marvell>> load scsi 0 $kernel_addr_r  efi/boot/bootaa64.efi
262620 bytes read in 26 ms (46.3 MiB/s)
Marvell>> bootefi  $kernel_addr_r
## Starting EFI application at 07000000 ...
Scanning disk sdhci@6e0000.blk...
Scanning disk ahci_scsi.id1lun0...
Found 5 disks
"Synchronous Abort" handler, esr 0x96000046
elr: 0000000000063728 lr : 000000000005b51c (reloc)
elr: 000000007ff9c728 lr : 000000007ff9451c
x0 : 00000000bffff000 x1 : 0000000000000000
x2 : 000000000000001f x3 : 00000000bffff018
x4 : 00000000bffff008 x5 : 0000000000000000
x6 : 0000000000000003 x7 : 00000000bffff020
x8 : 000000007f900000 x9 : 0000000000000008
x10: 0000000000000006 x11: 0000000000000006
x12: 000000000001869f x13: 0000000000000022
x14: 0000000000000000 x15: 00000000ffffffff
x16: 0000000000000001 x17: 0000000000000008
x18: 000000007f628dd0 x19: 00000000bffff000
x20: 000000007e620040 x21: 000000007e61f040
x22: 0000000007000000 x23: 0000000000000000
x24: 000000007f6249e0 x25: 000000007ffa4000
x26: 0000000000000000 x27: 0000000000000000
x28: 000000007f6c4670 x29: 000000007f624980
Resetting CPU ...

resetting ...

GlobalScale U-boot does not work correctly with efi.

Boards, SoCs, Vendors

Comments are closed.